-- *****************************************************************
-- CISCO-ITP-GACT-MIB: MIB Accounting information for SS7
--
-- September 2002, John Linton, Shekhar Acharya
--
-- Copyright (c) 2002-2003 by Cisco Systems, Inc.
-- All rights reserved.
-- *****************************************************************
--
-- *****************************************************************CISCO-ITP-GACT-MIB DEFINITIONS::=BEGINIMPORTSMODULE-IDENTITY,OBJECT-TYPE,Counter32FROM SNMPv2-SMI
MODULE-COMPLIANCE,OBJECT-GROUPFROM SNMPv2-CONF
cgspInstNetwork
FROM CISCO-ITP-GSP-MIB
CItpTcGlobalTitleSelectorName,
CItpTcGtaLongAddr,
CItpTcLinksetId,
CItpTcPointCode,
CItpTcServiceIndicator
FROM CISCO-ITP-TC-MIB
ciscoMgmt
FROM CISCO-SMI;ciscoGactMIB MODULE-IDENTITYLAST-UPDATED"200303030000Z"ORGANIZATION"Cisco Systems, Inc."CONTACT-INFO" Cisco Systems, Inc
Customer Service
Postal: 170 W. Tasman Drive
San Jose, CA 95134
USA
Tel: +1 800 553-NETS
E-mail: cs-ss7@cisco.com"DESCRIPTION"The MIB for providing information specified
in ITU Q752 Monitoring and Measurements for
Signalling System No. 7(SS7) Network.
This information can be used to manage messages
transported over SS7 Network via Cisco IP
Transfer Point.
The Cisco IP Transfer Point (ITP) is a hardware
and software solution that transports SS7 traffic
using IP. Each ITP node provides function similar
to SS7 signalling point.
The relevant ITU documents describing this technology
is the ITU Q series, including ITU Q.700: Introduction
to CCITT Signalling System No. 7 and ITU Q.701
Functional description of the message transfer part
(MTP) of Signalling System No. 7."REVISION"200303030000Z"DESCRIPTION"Initial version of this MIB module."::={ ciscoMgmt 333}-- Top-level structure of the MIBcgactMIBNotifs OBJECTIDENTIFIER::={ ciscoGactMIB 0}cgactMIBObjects OBJECTIDENTIFIER::={ ciscoGactMIB 1}cgactMIBConform OBJECTIDENTIFIER::={ ciscoGactMIB 2}cgactMtp3 OBJECTIDENTIFIER::={ cgactMIBObjects 1}cgactGtt OBJECTIDENTIFIER::={ cgactMIBObjects 2}
-- *************************************************************
-- * *
-- * SP - Mtp3 Accounting Table *
-- * *
-- * This table supports Q752/6.6 and Q752/6.7 *
-- *************************************************************cgactMtp3Table OBJECT-TYPESYNTAXSEQUENCEOF CgactMtp3TableEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"This table contains information about the number
of packets and bytes at the MTP3 transport layer.
The information collected from both directions(send
and receive). The information is broken down
by linkset, Destination Point Code (DPC),
Originating Point Code (OPC) and Signalling
Indicator (SI). This provides the lowest granularity
required by Q752 and allows network management
stations to calculate the required fields in Q752."::={ cgactMtp3 1}cgactMtp3TableEntry OBJECT-TYPE
SYNTAX CgactMtp3TableEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"A list of MTP3 accounting objects. Objects are
created in this table as traffic is received
and processed. "INDEX{
cgspInstNetwork,
cgactMtp3TableId,
cgactMtp3LinksetName,
cgactMtp3Dpc,
cgactMtp3Opc,
cgactMtp3SI
}::={ cgactMtp3Table 1}
CgactMtp3TableEntry ::=SEQUENCE{
cgactMtp3TableId INTEGER,
cgactMtp3LinksetName CItpTcLinksetId,
cgactMtp3Dpc CItpTcPointCode,
cgactMtp3Opc CItpTcPointCode,
cgactMtp3SI CItpTcServiceIndicator,
cgactMtp3InPackets Counter32,
cgactMtp3OutPackets Counter32,
cgactMtp3InOctets Counter32,
cgactMtp3OutOctets Counter32}cgactMtp3TableId OBJECT-TYPESYNTAXINTEGER{passed(1),violation(2),unroutable(3)}MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The accounting table identifier.
'passed' : signifies that this table instance
represents statistics for packets that
matched an Access Control List (ACL) in
the linkset's inbound ACL and in the
outbound ACL.
'violation' : signifies that this table instance
represents statistics for packets that
did not match an ACL in the linkset's
inbound ACL and in the outbound ACL.
'unroutable' : packets that pass access list verification
but can not be sent to destination point
code. This could be caused by incorrect
or missing route statements or inaccessible
destination."::={ cgactMtp3TableEntry 1}cgactMtp3LinksetName OBJECT-TYPESYNTAX CItpTcLinksetId
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The name of the linkset."::={ cgactMtp3TableEntry 2}cgactMtp3Dpc OBJECT-TYPESYNTAX CItpTcPointCode
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The destination point code."::={ cgactMtp3TableEntry 3}cgactMtp3Opc OBJECT-TYPE
SYNTAX CItpTcPointCode
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The origin point code."::={ cgactMtp3TableEntry 4}cgactMtp3SI OBJECT-TYPESYNTAX CItpTcServiceIndicator
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The service indicator."::={ cgactMtp3TableEntry 5}cgactMtp3InPackets OBJECT-TYPESYNTAXCounter32UNITS"packets"MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"The accumulated number of packets that have been received
by this linkset, DPC and OPC combination since system
startup."::={ cgactMtp3TableEntry 6}cgactMtp3OutPackets OBJECT-TYPESYNTAXCounter32UNITS"packets"MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"The accumulated number of packets that have been sent
using this linkset, DPC and OPC combination since system
startup."::={ cgactMtp3TableEntry 7}cgactMtp3InOctets OBJECT-TYPESYNTAXCounter32UNITS"octets"MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"The accumulated number of bytes that have been received
using this linkset, DPC and OPC combination since system
startup."::={ cgactMtp3TableEntry 8}
cgactMtp3OutOctets OBJECT-TYPESYNTAXCounter32UNITS"octets"MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"The accumulated number of bytes that have been sent
using this linkset, DPC and OPC combination since
system startup."::={ cgactMtp3TableEntry 9}-- *************************************************************
-- * *
-- * Global Title Translation - Accounting Table *
-- * *
-- *************************************************************cgactGttTable OBJECT-TYPESYNTAXSEQUENCEOF CgactGttTableEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"This table contains information about the number
of packets and octets required for global title
translation."::={ cgactGtt 1}cgactGttTableEntry OBJECT-TYPESYNTAX CgactGttTableEntry
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"A list of Global Title Translation accounting objects.
Objects are created in this table when MTP3 packets are
received requiring global title translation. "INDEX{
cgspInstNetwork,
cgactGttLinksetName,
cgactGttSelectorName,
cgactGttGta,
cgactGttTranslatedPc
}::={ cgactGttTable 1}
CgactGttTableEntry ::=SEQUENCE{
cgactGttLinksetName CItpTcLinksetId,
cgactGttSelectorName CItpTcGlobalTitleSelectorName,
cgactGttGta CItpTcGtaLongAddr,
cgactGttTranslatedPc CItpTcPointCode,
cgactGttPackets Counter32,
cgactGttOctets Counter32}cgactGttLinksetName OBJECT-TYPESYNTAX CItpTcLinksetId
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The name of the linkset."::={ cgactGttTableEntry 1}cgactGttSelectorName OBJECT-TYPESYNTAX CItpTcGlobalTitleSelectorName
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The Global Title Selector Name."::={ cgactGttTableEntry 2}cgactGttGta OBJECT-TYPESYNTAX CItpTcGtaLongAddr
MAX-ACCESSnot-accessible
STATUScurrentDESCRIPTION"The Global Title Address."::={ cgactGttTableEntry 3}cgactGttTranslatedPc OBJECT-TYPESYNTAX CItpTcPointCode
MAX-ACCESSnot-accessibleSTATUScurrentDESCRIPTION"The translated point code."::={ cgactGttTableEntry 4}cgactGttPackets OBJECT-TYPESYNTAXCounter32UNITS"packets"MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"The accumulated number of packets received by this
signalling point requiring global title translation
since system startup."::={ cgactGttTableEntry 5}
cgactGttOctets OBJECT-TYPESYNTAXCounter32UNITS"octets"MAX-ACCESSread-onlySTATUScurrentDESCRIPTION"The accumulated number of bytes received by this
signalling point requiring global title translation
since system startup."::={ cgactGttTableEntry 6}-- *************************************************************
-- * *
-- * Conformance Information *
-- * *
-- *************************************************************ciscoGactMIBCompliances OBJECTIDENTIFIER::={ cgactMIBConform 1}ciscoGactMIBGroups OBJECTIDENTIFIER::={ cgactMIBConform 2}-- ComplianceciscoGactMIBCompliance MODULE-COMPLIANCE
STATUScurrentDESCRIPTION"The compliance statement for entities which implement
the Cisco SP MIB"MODULE-- this moduleMANDATORY-GROUPS{
ciscoGactMtp3Group,
ciscoGactGttGroup
}::={ ciscoGactMIBCompliances 1}-- Units of ConformanceciscoGactMtp3Group OBJECT-GROUPOBJECTS{
cgactMtp3InPackets,
cgactMtp3OutPackets,
cgactMtp3InOctets,
cgactMtp3OutOctets
}STATUScurrentDESCRIPTION"A collection of objects providing MTP3 accounting feature."::={ ciscoGactMIBGroups 1}ciscoGactGttGroup OBJECT-GROUPOBJECTS{
cgactGttPackets,
cgactGttOctets
}STATUScurrentDESCRIPTION"A collection of objects providing Global Title Translation
accounting feature."::={ ciscoGactMIBGroups 2}END